BRAND NEW FREE SHIPPING FOR ALL USA This windshield wiper puller removes wiper arms on many foreign and domestic cars and light trucks. Simply place puller feet under wiper arm and tighten forcing screw against wiper shaft removing the arm without damage to the arm, hood, or cowling.
- Removes wiper arms on many foreign and domestic cars and light trucks.
- Will not damage wiper arm or hood cowling during removal.
- Easy to operate:Simply place puller feet under wiper arm and tighten forcing screw against wiper shaft.
- Removes windscreen wiper arms easily and safely, avoids damage to vehicle bodywork or wiper assembly.
- Corrosion-resistant chrome plating,suitable for straight and spline spigots.
- Suitable for straight and spline spigots up to 15mm diameter.
- How to Use:
1. Removes wiper arms on many foreign and domestic cars and light trucks.
2. Not to damage wiper arm or hood cowling during removal.
3. Simply place puller feet under wiper arm and tighten forcing screw against wiper shaft. - Included: 1 pc Wiper Arm Remover Tool
Note: Measuring tape is NOT included. Measuring tape is for size reference purposes only. Check the size of your wiper arms first, this was on the small size and ended up using a regular puller instead. It works on smaller cars, but trucks and SUV’s with larger wipers may be too large for this to fit around or get the center pin onto.Be careful of depth. Measure how deep your arm reaches and verify this will fit. There are two requirements in this item. How wide the base of the puller is (if the opening isn’t big enough to get around the sprocket holding the windshield arm on) and how “deep” the windshield arm is from its base to the tip of the bolt. Nobody says how deep a windshield arm they will successfully pull. As you can see from the picture, this will pull one about 3/4″ deep.